AODD Pump Blog & Technical Articles

AODD Pump Blog & Technical Articles

Uncategorized

DAVE’S CORNER: HIGH PRESSURE PUMPS

The installation of a Yamada high pressure pump is the same as a standard Yamada Air-Operated Double Diaphragm pump. The bottom port is the liquid suction; the top port is the liquid discharge, etc. The main difference is the pumps ability to generate twice as much discharge pressure as air pressure, a 2 to 1 ratio.

Uncategorized

DAVE’S CORNER: XDP PUMP WITH CYCLE COUNTER

With the introduction of the XDP Series pumps we needed to use a proximity sensor other than the P1 and P2 sensors used on the rest of the Yamada product line, which sense the position of the C-Spool to count the cycles of the pump.

Uncategorized

DAVE’S CORNER: DIAPHRAGM FOR NDP-20/25 SERIES PUMPS

In August of 2008 the NDP-20 / NDP-25 series pumps came with a new style diaphragm which has an o-ring molded into the air side. This change was made for two reasons: To prevent air leaks where the diaphragm contacts the air chamber. To prevent a diaphragm from pulling out of place if there is excessive air pressure.

Helpful Hints

HELPFUL HINTS: DIAPHRAGM CYCLE LIFE VS. MAXIMUM FLOW RATE

I often receive phone calls from end users about diaphragm cycle life and the first few questions I ask are: What pump are they using? What chemicals are they using and at what temperature? Is it a suction lift application or a flooded suction? At what flow rate are they operating the pump? After discussing these questions I find that several customers are running the pump at full throttle…

Helpful Hints

HELPFUL HINTS: DRUM PUMPS

Yamada makes drum pumps in 3 port sizes. The 3/8” pump is available in Aluminum and Stainless Steel. The 1/2” pump is available in Polypropylene or Kynar. The 3/4” pump is available in Polypropylene, Aluminum or Stainless Steel.

About the Author

Default Admin User
Default Admin User

Categories

Technical Overview

Diaphragm Pump Anatomy